Author Topic: Setpoint command causing dcad to crash.  (Read 35 times)

Lar

  • Hero Member
  • *****
  • Posts: 2866
Setpoint command causing dcad to crash.
« on: May 14, 2019, 09:51:58 PM »

I have a fairly complicated macro that usually causes dcad to crash when it encounters this line of code:


setpoint "... ... ...", 1


It doesn't happen all the time but about half the time. It didn't have the comma at first but putting the comma in did not help. Funny thing is, I had to put 2 setpoints back to back because the macro totally ignores the first setpoint it encounters. That is why I don't have an actual message in the quotes.


Anybody else experiencing this issue? I don't experience any problems with any other macro that has setpoint, so something in the code leading up to it must be causing the problem. Thing is, if I choose the option where the macro does not read that line, then the macro performs perfectly.




Lar